Firmware v1.00.0300

Hey all,

First and foremost - thanks to all at NLD for making this possible. Your hard work and efforts are appreciated!

Forgive me, because this is my first drone, so I'm still getting used to wrapping my head around how DJI does some of its crazy things.

My M2P is on v1.00.0300 - I don't see that on the firmware blowout. Does that mean it's not supported?

Can I downgrade to v1.0.0100 to use NLD? Looks like maybe DJI Assistant will allow me to do this, just looking for confirmation.

Thanks again!

es bien raro, porque hablan de una versión V00.06.0000
pero como vos decís en el M2P el ultimo FW que se pudo actualizar fue el .0300 ... y tampoco se ve el check de  altitud removal .... seguramente son detalles que se estarán cocinando estos próximos días, espero se solucione pronto

Use NLD to downgrade your firmware.  Assistant doesn't work.

Assistant let me downgrade from .300 to .200 but no lower, then I used NLD to downgrade to.100

I have been tackling this for a couple of hours, with crashed downgrades and errors etc. Here is where I am at;

Use Assistant 2 to downgrade to v1.00.0200, it won't let you downgrade anything older even if it says it can (this is my experience, YMMV)

Using NLD to downgrade to v1.00.0100 or v1.00.0000 from v1.00.0200, I am on this part at the moment and since downgrading to .0200 using Assistant after downloading from NLD CDN it fails to go into upgrade mode. Prior to downgrading to .0200 it just crashed each time I attempted the downgrade.

Jamie wrote:
This is currently the way to do it.

Even though Assistant 2 shows you can downgrade to 0100, they actually dont have the firmware file on their servers any longer which is why the downgrade fails.

Thanks for confirming CS2000, I've been stuck on downgrading via NLD below 1.00.0200 for a few hours and going to have to walk away for a bit as making no progress. Will try again later on, sometimes it states cannot go into update mode, other times it starts to do the downgrade and completely crashes.

Thanks all! I've successfully downgraded.

Here are the steps I took from v1.00.0400

1. Attempted to downgrade to v1.0.0100 via DJI Assistant (obviously did not work)
2. Downgraded successfully to v1.00.0200 via DJI Assistant
3. Used NLD to downgrade to v1.00.0100 and applied NFZ patch

I've tried doing it so many different ways, I'm now stuck on getting as far as 3% firmware install (wm240_0801_v10.00.07.30_20180925.pro.fw.sig) when trying to go from .0200 to .0100.

It seems like a lot of people have been successful so maybe I've noobed it somewhere along the line! If I figure it out I will put up a reply on here.

Scott wrote:

Is it giving you an error message? I had some issues with access violation errors during upload to drone but running in compatibility mode for widows 7 fixed it. Maybe try some compatibility modes and as always running as admin see if it helps things.