Disable critical battery forced landing

Hi, can anyone help me disable the forced landing mode that happens in the Mavic Pro when the battery is deemed "critically low"? I've tried turning everything off in Go 4.

Here's the situation: I turned off the altitude limit with NLD so I can fly up a mountain ridge (still staying 400ft AGL). It takes a fair bit of juice to eventually get a mile up and two miles away, and so even with all battery options turned off in Go 4, at around 60% battery the bird freaks out that it's so far away and goes into forced landing mode. Although I can still control it, it's a pain because it's out of Sports+ mode, drops altitude without me knowing it, and the nonstop RC beeping drives me nuts.

Returning down the ridge from that distance requires very little battery-- it's basically a glider, so by the time I get back the battery is still around 40%.

Second that motion
I have the same issue with critical Low battery Forced landing.

I'm running Mavic pro  firmware  1.03.700 and  Go4 version 4.1.22
.
it's has to be in the perameters menu

RC beeping = use Silencio mod on the controller.  (You are welcome)

As for the forced landing... I like this idea.
BUT.
The scary part is that if "Joe Blow the drone guy" flies this thing at 400' AGL and ignored the landing/battery part; this thing is going to drop out of the sky and possibly damage/hurt someone and of coarse destroy his drone by smashing it into pieces. NLD then gets the rep as a dangerous mod and lawsuits follow. (because people like to sue for shit like this)

I have played with the battery drain over a controlled site and eventually after forcing it to fly at 8" with 0% battery it eventually gave out and dropped to the mat. Usually 1 motor fails because there is not enough juice to sustain.

I get that this is not what you are doing.. but you have to think past YOU on this one.

Good Luck!

Bob wrote:
.
.
I get that.!

I'm  pretty sure
  nobody want to hurts anybody through negect.!

.... But a forced landing
Because of low battery (warning)  in which the downward sensors are turned off  is not favorable  either...

I'm a water flier
And if I'm going  in the drink
I don't  want Mavic to go in with 20% battery left onboard .

I would prefer
Bring it home (on land)
with a bad battery on board because I  discharged  far below the allowable  voltage

I dont reccomend anyone does this, but its your drone. This disables everything related to battery monitoring in terms of remaining battery life time estimates, RTH warnings and auto landing.

Turn off Auto Land on low battery
01.03.400 no changes needed, 01.03.700 need to disable Precision landing in GO APP for these settings to work, otherwise they are overridden by precision landing.

DJI Assistant 2 Parameters
{"SEQ":"123456","CMD":"write","INDEX":"g_config_landing_auto_landing_vel_L1","VALUE":-1}
{"SEQ":"123456","CMD":"write","INDEX":"g_config_landing_auto_landing_vel_L2","VALUE":-6}


Parameter Names (for NLD) () are defaults

g_config_landing_auto_landing_vel_L1 = -1 (-1)
g_config_landing_auto_landing_vel_L2 = -6 (-3)

This is bad news all around. It will be a great way to crash. At 8% my mavic fell out of the sky. Each battery will act different. I wish there was a way to cancel the forced landing or atleast take it away once you get back to a distance that the drone recognizes it has enough battery left. The speed is also set for decent way to slow. 11mph is the max. How could we increase this where its faster?